Red Triple-Contact Dual-Loop Couples Vibrator

One integrated red body defines this exact offer

The exact supplier images show a single connected device rather than a box of three separate toys: one rounded central housing, one rose-shaped contact pad, one long ridged arm, two flexible loops and one extended leaf-tipped tail. This page is tied only to Alibaba offer 1601698822844 and the Red selector.

Three visible contact areas need separate output mapping

The rose pad, ridged arm and leaf-shaped tail are the three distinct contact areas visible in every exact product graphic. Internal motor count, which area moves, output level, phase relationship and whether zones can be controlled independently are not documented.

Two loops form the central retention structure

A smaller upper loop and larger lower loop are moulded into the body. Their relaxed opening, stretched opening, wall thickness, restoring force, edge radius and cycle life are not published, so no universal fit or pressure claim is made.

The tail is not approved as an insertable component

The supplier title uses anal-thruster wording, but the page does not state usable length, maximum width, neck geometry, retention method or loaded motion. Until a physical sample and model-specific manual resolve those points, this catalogue describes the tail only as a flexible contact extension and does not endorse internal use.

Red is the only selectable colour

The live offer presents one Red selector. Preview inventory is therefore a single SKU with 200 planning units; this does not represent confirmed supplier-ready stock or a production reservation.

Supplier artwork supplies provisional measurements

One exact graphic marks approximately 287 mm overall, 119 mm across the projecting contact section, 106 mm for the rounded housing area, a 33 mm upper-loop opening, 43 mm lower-loop opening and 54 mm lower outer width. Orientation and measurement endpoints are not fully explained, so every value requires sample verification.

The control method conflicts across the same page

The offer title says remote control, while exact feature graphics show a mobile phone and describe phone control. No handheld remote is pictured in the selected product views. The storefront therefore does not promise either control path until the supplier provides the exact accessory list, controller photograph and manual.

Nine and ten pattern statements do not agree

The attribute table states ten frequencies, but exact feature artwork shows nine waveform icons. Neither source provides a button map, zone routing, intensity steps, pause behavior or emergency-stop logic. Pattern count is withheld as a confirmed specification.

Connection loss must lead to a predictable stop

If the production unit is app controlled, approval requires testing for pairing, reconnect behavior, account requirements, permissions, privacy policy, update support and what happens when the phone, network or application disconnects. A local stop control must remain reachable.

Silicone plus ABS is a supplier declaration only

The page names silicone and ABS without identifying which component uses each material, silicone grade, hardness, cure system, pigment, restricted-substance report or batch traceability. No medical-grade, hypoallergenic or body-safe claim is made.

Waterproof wording is not an ingress rating

The marketplace says 100% waterproof but publishes no IP code, laboratory report, depth, duration or charging-port condition. Keep the device and charging area away from immersion until a production-matched ingress test and cleaning instruction are approved.

Battery and charging specifications are absent

USB rechargeability is listed, but connector type, cable contents, battery chemistry, capacity, input rating, charge time, runtime, low-power behavior, transport documents and replaceability are missing. Do not use or charge a sample that is hot, swollen, damaged or wet.

The sound figure has no test method

The page states 50 dB and elsewhere under 50 dB without distance, room noise, mode, load or measurement equipment. Acoustic performance must be measured at each contact zone and operating state before quiet-use language can be accepted.

Fit testing starts with the loops at rest

Before powered trials, measure both loop openings relaxed and under controlled stretch, record restoring force and inspect all mould seams. A loop that causes pain, numbness, discoloration, coldness, swelling or loss of sensation must be removed immediately.

Initial validation stays external and low intensity

Learn the stop control first, test each zone externally, begin at the lowest verified setting and add one function at a time. Stop for sharp pain, unexpected movement, persistent irritation, unusual heat, bleeding or any control failure.

Cleaning must account for folds and junctions

Power off and disconnect charging before cleaning. The rose folds, ridged arm, loop junctions, tail groove and housing seams require careful access, but rinsing, soaking, cleaner choice and drying procedure remain limited by the unresolved ingress and material evidence.

Inspect the complete moulded path before every use

Quarantine any unit with tears, tackiness, whitening under stretch, exposed gaps, sharp flash, colour transfer, loose seams, abnormal noise, heat, charging damage or unpredictable starts and stops. Do not repair a powered contact product with adhesive.

Packing data conflict by a wide margin

An attribute lists 20 x 15 x 10 cm and 0.2 kg product weight, while the shipping table lists 30 x 20 x 15 cm and 1.0 kg gross. Box contents, controller, cable, manual, inner tray, actual net weight, carton quantity and master-carton data remain pending.

EUR 6.65 is the conservative source reference

The live tiers are EUR 6.65 for 2-499 pieces, EUR 6.39 for 500-999 and EUR 5.08 from 1,000. The 200-unit plan uses EUR 6.65 before China-to-Portugal freight, clearance, duty and VAT where applicable; no shipping solution is confirmed.

EUR 44.99 is a provisional retail plan

The plan allows for freight, three-zone mapping, controller and disconnect tests, loop fatigue and fit inspection, battery, charging, sound, ingress and material review, discreet packing, payment cost and expected quality loss. It is not a launch commitment.

Frequently asked questions

Is this three separate products?

No. The exact images show one integrated device with three visible contact areas and two loops.

Does it include a handheld remote?

That is not confirmed. The title says remote, while exact graphics show phone control and no remote accessory.

How many patterns does it have?

The page conflicts between nine and ten, so the final count awaits a production sample and manual.

Can the tail be used internally?

Not on the current evidence. Insertable length, width, retention and motion limits are not established.

Is it waterproof?

No verified immersion claim is published because the supplier gives no IP rating or test report.

What comes in the box?

The device is visible, but the controller, cable, manual and packaging contents require a signed packing list.

Sales opening waits for exact control and fit evidence

Anonymous purchasing remains disabled until samples confirm the complete model, control method, local stop and disconnect behavior, mode and zone map, all dimensions, loop stretch and restoring force, tail purpose, component materials, battery, charging, sound, ingress, cleaning, pack contents, conformity evidence, image rights, warranty, defect terms and a written 200-piece landed-cost quote.