Z0006 is tied to one black remote-control configuration
This review page maps to Alibaba offer 1600056224259 from Shenzhen Fantasy Technology Co., Ltd.. The exact gallery consistently shows a black leaf-shaped plug, an onboard power button and a separate oval remote, keeping the selected housing and controller together under model Z0006.

A tapered leaf profile carries diagonal raised ribs
The insertable section narrows at the tip and widens toward the lower bulb. Spiral-like surface ridges run diagonally across it; their height, softness and spacing are not specified, so edge finish and cleanability must be checked on the sample.
The dotted neck leads into a broad retrieval base
Rows of small raised dots cover the narrower neck above a wide curved base. The base is visibly wider than the neck, but maximum insertable width, neck diameter, base span, usable length and manufacturing tolerance still require direct measurement.
The supplier lists 151.8 by 58.3 millimetres
Those overall dimensions identify the product envelope rather than an approved insertable measurement. The catalogue does not reinterpret 58.3 mm as a usable diameter because the value may describe the base width.
Ten vibration modes are the only accepted setting count
The structured field states ten frequency patterns. The exact waveform sequence, intensity steps, motor placement, switching direction and behaviour after shutdown remain pending a production sample and button map.
The onboard button keeps local control available
A recessed power symbol appears on the curved base. Press duration, mode advance, indicator feedback, child lock and low-battery signal are not visible in the supplier evidence and must be documented before customer instructions are final.
The oval remote uses two distinct controls
The remote face shows an upper circular button and a lower M-marked button. Remote range, radio protocol, battery type, pairing process, simultaneous use with the onboard button and interference behaviour are not stated.

Remote inclusion is supported visually but needs a packing list
Multiple exact gallery views pair the plug and remote, and the feature field says remote control. Final receiving documents still need to name the remote, charging lead, instructions and any other included pieces explicitly.
Rear contacts indicate a dedicated charging interface
The rear supplier view shows a small DC marking and two contacts on the base. Connector style, polarity, input voltage, current, cable length and adapter inclusion are not supplied in the inspected fields.

The battery line reads 400mAh and 7.4V
That combined supplier wording is recorded exactly, not treated as a verified cell specification. The production battery label, cell arrangement, protection circuit, transport report and charger compatibility must reconcile the voltage before procurement.
Two hours of charging is paired with one hour of use
The page states 120 minutes to charge and 60 minutes of working time. It does not disclose which setting, remote activity, battery age or test method produced the runtime, so incoming testing should measure several modes.
The noise ceiling lacks measurement conditions
The supplier field says <=55 dB. Distance, room baseline, mounting, mode and meter standard are absent; the product is not described as silent until a repeatable internal test supports that language.
Silicone and ABS need component-level mapping
The material selector reads silicone/ABS. The soft outer surface and rigid internal or control parts cannot be assigned by assumption. Grades, hardness, pigments, adhesives, restricted-substance evidence and body-contact documentation remain pending.
Waterproof wording is not an accepted ingress rating
The supplier says 100% waterproof, but no model-matched test report or IP level was shown. Keep the charging contacts dry, never charge a damp unit and avoid immersion until production instructions and an ingress report define the boundary.
Cleaning should protect the seams and contacts
Power off, disconnect charging equipment and wipe the confirmed washable exterior with mild soap and lukewarm water. Rinse residue cautiously, dry fully and store separately. Do not boil, bleach or use abrasive solvents.
Use starts with inspection and the lowest available setting
Check the surface, neck and base for tears, tackiness, sharp seams or contamination. Apply a lubricant confirmed compatible with the production silicone, proceed gradually and stop for pain, numbness, swelling, bleeding, excess heat or persistent irritation.
The package record is 18 by 6 by 6 centimetres
Single-package gross weight is listed as 0.35 kg while the product itself is listed at 210 g. Box style, protective insert, cable, remote, instruction sheet, carton quantity and master-carton measurements remain pending.
Incoming inspection must cover both controllers
Verify model, colour, dimensions, weight, surface finish, base rigidity, neck resilience, remote pairing and range, every mode, contact alignment, full charge time, runtime, noise, temperature and fault shutdown. Segregate split, sticky, contaminated, unstable or overheated units.
EUR 11.11 is the visible 200-unit source tier
The offer lists EUR 12.08 for 30–49 pieces, EUR 11.46 for 50–99 and EUR 11.11 from 100. Two hundred units therefore represent EUR 2222.00 product value before freight, duty, VAT, insurance, payment fees and quality loss.
EUR 54.99 remains a freight-aware planning price
No selected 200-unit shipping amount was displayed. The preview price leaves room for China-to-Portugal transport, battery handling, controller and mode inspection, discreet fulfilment and expected quality loss, then requires recalculation from a written landed quotation.
Frequently asked questions
Which colour is selected?
Black. The gallery and published inventory record do not mix another colour.
How many vibration settings are documented?
Ten supplier-stated modes; their order and intensity map remain pending testing.
Can it work without the remote?
An onboard power button is visible, but its full mode-control capability needs the production instructions.
Is it safe to submerge?
No immersion promise is made because a product-specific ingress report was not supplied.
What comes in the box?
The plug and remote are pictured together; the complete production packing list, cable and instruction contents remain pending.
Is EUR 54.99 final?
No. It is a provisional planning price until sample approval and landed costs are confirmed.
Published for review while the storefront stays closed
Authenticated reviewers can inspect this page, but anonymous visitors remain behind Coming Soon. Sales stay disabled until dimensions, materials, ten-mode mapping, remote protocol, battery, charging, runtime, noise, ingress, cleaning, packing, conformity, image rights, freight, tax and commercial terms are approved.
| Supplier model | Z0006 |
|---|---|
| Selected colour | Black |
| Listed dimensions | 151.8 x 58.3 mm overall; usable dimensions pending |
| Listed weights | 210 g product; 0.35 kg single-package gross |
| Material evidence | Silicone/ABS; grades and component mapping pending |
| Control evidence | 10 vibration modes; onboard button and two-button wireless remote |
| Power evidence | 400mAh/7.4V supplier wording; 120-minute charge and 60-minute use; validation pending |
| Ingress evidence | 100% waterproof supplier wording; model-specific report pending |








Reviews
There are no reviews yet.